How to solve the clogging of the sand maker?

Sand during operation may cause clogging due to various reasons. Yihong machinery is here for you to provide a good solution ideas. One possibility is to feed too fast, too much load on the machine, there is no way in time for the inside of the material crushing, sent, and the outside is still adding new material, so there is no way to run a machine. Know the amount of feed crus her is suitable for it?

The main changes you observe pointer ammeter, big time feed rate meter pointer deflection angle will be great, if more than the rated current, to show that the motor overload, if prolonged overload will cause the motor burned out. Such a situation should immediately turn off the inlet, you can also change the way the feed so as to achieve the purpose of feeding is not excessive. Feeder manual and automatic, the user can make the selection according to their needs, if Sand's load, fast speed, then the machine is also large fluctuations, so it is necessary to observe the current index according to the machine load, the general provisions in the Sand 85% of the rated power is appropriate.

The second reason may cause new Sand blockage. The material poor, usually pipe deformation of the material, equipment or transportation pipeline stagnation caused by wind or no wind weakened state. Find out what the reasons are timely corrected, replace the appropriate delivery device can not let such a thing happen. Other possible causes of aging hammer crusher is clogged, broken, broken in a sieve, sieve case can also cause blockage blocked. Excessive moisture content of materials also appear blocked.